Masako Cynesige

Total activity 109
Last activity February 07, 2020 10:35
Member since December 04, 2019 14:01

Following 0 users
Followed by 0 users
Votes 12
Subscriptions 43

Comments

Recent activity by Masako Cynesige

Here's a visual for your assistance:
- View comment
- Created December 20, 2019 13:02
- 1 vote
Hi There! According to Manual: (Inspection 1) Confirm that fuse FUSE2 on the emergency stop printed circuit board is not blown. When it is blown, the LED on the emergency stop printed circuit board...
- View comment
- Created December 20, 2019 12:59
- 1 vote
Hello, Here is the procedure,Offset using REGISTERS R[28:OffsetValue]=25andPR[10] would intitially be at 0,0,0,0,0,0 for xyzwpr !Place the part!L PR[40:PartPlaceLocn] (Dis)mm/secOffset, PR[10] !Cha...
- View comment
- Created December 11, 2019 17:05
- 1 vote
Thanks sarwat. 👍
- View comment
- Created February 07, 2020 10:35
- 0 votes
Thanks sarwat and dimitry for this help 🤗
- View comment
- Created February 07, 2020 10:01
- 0 votes
Thanks Dimitry, I appreciate the information you provided. ✌
- View comment
- Created February 07, 2020 09:59
- 0 votes
Oh Thanks for letting me know though. ✌
- View comment
- Created February 07, 2020 09:54
- 0 votes
Issue was resolved. it was too many volts for the amount of wire I were using. Thanks
- View comment
- Created February 07, 2020 09:52
- 0 votes
It was really helping Sarwat. Thanks! 🤗
- View comment
- Created February 07, 2020 09:38
- 0 votes
Dear Fredric Demps Please find below explanation of JOG-013 WARN Stroke limit (G:%d A:%x Hex) Cause: Robot axis reaches its specified stroke limit. Remedy: The robot already reach the stroke limit...
- View comment
- Created February 06, 2020 16:00
- 0 votes