Juan Turner
Comments
-
In the main user frame the prompt was supposed to be "Active UFRAME $MNUFRAMNUM[1]=0". However, someone had pushed it to SETIND which has changed the bits from 0 to 1. When I used the CLRIND and it...
-
It is showing prompts on each time the program is being run in case if they have to touch up a weld point.
-
Heloo, I would like to know what is your main program called? its name? Give details.
-
Laurance, yes, you are right to some extent. I have even tried to replace it's CPU with another but it was still not bootable. However, after i have changed the entire controller, it re-booted and ...
-
hi Franki Before i suggest you with any solution, i would like to know that are you able to jog with your robot? The problem may lies in tool orientation and the robot might want to grip the part y...
-
Hi howard, it may sometimes happen because of having an interconnection with that "DO" and by the time when you are trying to turn it OFF it always stays ON no matter what. Similarly, if the digita...
-
Hi, I think you should note down model number and serial number of the robot and contact the FANUC supplier. Someone may answer you but it would not be up to the mark information
-
Have you ever tried using one of UOP signals in the interlock? I guess its name is CMDENBL. I believe there is any UOP signal from where the robot from where the robot has indicated AUTO such as th...
-
Dear Frankie!The CPC is capable to control the ESPDO output through use of Safe I/O Connect; SPO[1]=CPC[1].
-
Hi. I am glad that I know this answer. You have to setup up a DCS zone as Status only to monitor the area you want. Then use Safe I/O Connect to drive the ESPDO1 by the status of your DCS zone. It ...