Howard Coleman
Comments
-
Dear Juan, Frankie is correct. Such a status would only happens with the robots in cases close to singularity. I am very happy that you have noticed this as if you have not then it may have run for...
-
I would suggest you to try hitting select and then monitor. It may help
-
Hi frankie, I think i have observed this in various of the applications such as food handling robots, die cast spray, and washing robots etc. However, one of the most common reasons is the alkalin...
-
Dear Frankie! As far as I think ROT is the robot's over travelling. SRVDSCNT is for the indication that SERVO motor is disconnected in OFF position. Good Luck
-
Dear Frankie, Go to Menu of your controller. Check the I/O. Type UOP. List it if not listed. This is very straightforward.Furthermore, the method demonstrated by Mr.Losev seems okay.
-
Dear Dimitry, Which controller are you using? If you are using the LRMATE then it is not supported there.
-
Hi all, Thank you so much for inputs. I have already found the variable but due to some reason i was just putting "=ON" instead of "1" which caused the trouble.
-
Hi The controller is R30iB and 8.20p/10
-
Hi Mr. Coleman, When it comes to the existing controller there are various options which you could try. The system config having an option for disallowing/allowing the simulations in auto mode ($A...
-
Most probably there is a problem with a few of the axis and you are needed be troubleshooted and you should apply repeated greasing. If you still have any problems then look at it one by one. Such ...