Frankie Ellis

1. Community
2. Electrical Design
3. What is meant by MOTN049 calibrated in FANUCs?

Hi Howard, you know by the time whenever a robot is mastered, it is then calibrated as well by the same time. All i want to say that it is lying in same menu. Got it?

• View comment
• Created January 09, 2020 12:13
• 0 votes

1. Community
2. Electrical Design
3. Ending effector input without connection (PPABN)

Dear chang, for your information i am having a robot having no EE connector and i am used to monitor pressure for which i am putting the pressure switch in that of the emergency circuit.

• View comment
• Created January 09, 2020 12:03
• 0 votes

1. Community
2. Troubleshooting — FANUC
3. Freezing up of RJ3 TP when push control stop---need help

Hi, I wanted to add up that recently it has started to happen that whenever it crashes, such as it has something for stopping the signal, I then went down the robot and gave it a reboot from its CP...

• View comment
• Created January 09, 2020 11:48
• 0 votes

1. Community
2. Troubleshooting — FANUC
3. Freezing up of RJ3 TP when push control stop---need help

Thank you for your response mr. Ishaq. I have changed the board on the back door of the robot and then also replaced the fuses over the robot in the same circuitry having problem of freezing. Basic...

• View comment
• Created January 08, 2020 06:46
• 0 votes

1. Community
2. Troubleshooting — FANUC
3. Bootup problems

Hey Juan, Before you think to change the entire CPU please try out the solution which I am suggesting. Electrolytic capacitors are the components used in Power Supply of the CPU. I think that some ...

• View comment
• Created December 20, 2019 11:35
• 0 votes

1. Community
2. Troubleshooting — FANUC
3. Problems faced in RoboGuide

Hi juan, thank you for your precious response but I am glad that I have found the solution myself. Actually it failed because of the grip and when I changed the grip, all problems automatically got...

• View comment
• Created December 19, 2019 09:40
• 0 votes

1. Community
2. Troubleshooting — FANUC
3. Why digital output never gets off?

hey howard Have you ever tried to check "CONFIG" over your digital output. Also have you checked "CONFIG" on the UOP. It is possible that these "DOs" are assigned to output of the system. Thanks

• View comment
• Created December 19, 2019 06:22
• 0 votes

1. Community
2. Troubleshooting — FANUC
3. how to reduce the tip dressing time of FANUC

Tip dresser (CDEL)FANUC motor brief version This has it all you need.

• View comment
• Created December 18, 2019 12:44
• 0 votes

1. Community
2. Troubleshooting — FANUC
3. Welding through s10 Fanuc

Hey laurance, before suggesting you a solution, i would like to inquire you about, Which of the software are you using? Is it ArcTool or any other?  

• View comment
• Created December 17, 2019 08:02
• 0 votes

1. Community
2. Mechanical Design
3. Is there a way for safe output from robot to pLC

Dear Juan, thank you so much for your help, i really appreciate it. Can you tell me does the CPC[1] point to the number of the DCS zone I have configured? If your answer is yes then please tell me ...

• View comment
• Created December 13, 2019 11:06
• 0 votes