Carl Welch

1. Community
2. Troubleshooting — FANUC
3. SRVO-233

Check if you have teach pendant is disabled or not while your controller is in T1 or T2 mode. Also check if your controller Door is open. Close the door. Set Teach pendant to On and Press Reset.  I...

• View comment
• Created March 17, 2020 15:16
• 1 vote

1. Community
2. Troubleshooting — FANUC
3. The robot position is out of stop tolerance

Check Resume Tolerance 

• View comment
• Created March 26, 2020 13:42
• 1 vote

1. Community
2. Mechanical Design
3. SPEED OVERRIDE

You Can define over ride speed in Production Checks  Menu -- Setup --Prog Select -- General Over Ride and Program Over Ride

• View comment
• Created March 26, 2020 08:38
• 0 votes

1. Community
2. Troubleshooting — FANUC
3. MOTN-017

Thank you so much .. You saved my day. !! 

• View comment
• Created March 21, 2020 14:02
• 0 votes

1. Community
2. Troubleshooting — FANUC
3. I/O Simulation

There is another settings you can give it a try.  GO TO MENU - SETUP - PROGRAM SELECT  Simulated I/O : DISABLED  (When  ENABLED, production run , If I/O are not simulated.)

• View comment
• Created March 19, 2020 07:23
• 0 votes