Mathieu Berube
Comments
-
Standard one
-
Hi, With that old teach, try to start the robot in the Boot monitor by holding F1 and F5 during the power ON and see if it's opening.
-
Hi, In that case, there's 2 options: 1. Check if the cable is correctly plugged in (USB and the twist connector on both side) 2. If it's not working, try to plug a standard Teach pendant:
-
Hi, The ESTOP and FENCE of a robot need to be closed with dry contacts. In this case, you need to have a dry contact that connects EESB1 to EES11, and another dry contact that connects EES2 to EES2...
-
Hi Cory, The MOTN-17 is for axis limit of the robot. Try pressing POSN and then F2 for JNT You should then see what's the position of each joint
-
Hi, Can you show us the cartesian zone in the DCS and the point you try to reach including the offset?
-
Hi, Do you have a cartesian zone programmed in the DCS?
-
Hi Mark, For the SVRO-038, when you press MENU - NEXT - SYSTEM , do you see a Master Cal option? If yes, have you tried to press RES_PCA?
-
Hi, If you have the Adapter, the only thing you can do is read the I/O in the robot with a scanner. If you can have the Cognex in scanner mode, you can read the trig I/O in the robot. Otherwise, yo...
-
Hi, Are you connected to the E-Stop unit CRMA74?