Masako Cynesige

1. Community
2. Troubleshooting — FANUC
3. NTED ERROR

Hi losev, Nice to reply your question here For "SRVO-275 NTED2 status abnormal" error: a chain alarm was detected with the NTED signal. Try Following actions to remove the error:   (Action 1): This...

• View comment
• Created December 04, 2019 14:01
• 2 votes

1. Community
2. Mechanical Design
3. Bin Picking original Package

Dear Bailey, Welcome Back! Here I am attaching the checklist of a real bin picking robot package: Best of Luck!

• View comment
• Edited February 02, 2020 13:26
• 1 vote

1. Community
2. Troubleshooting — FANUC
3. DNET-055

Braylen, Here what Manual says about DNET-055: DNET-055 STOP Board or network error: Bd %d Cause: An error has occurred with the specified daughter board or the Device Net network connected to it. ...

• View comment
• Edited February 02, 2020 08:46
• 1 vote

1. Community
2. Troubleshooting — FANUC
3. KAREL Code size exceeded

Dear pal, You receive this when the code gets too large, well that is pretty much obvious. Let me tell you how to fix this. You can separate the variables and constants in separate file and then yo...

• View comment
• Edited January 30, 2020 18:00
• 1 vote

1. Community
2. Troubleshooting — FANUC
3. “13007 Reset already in progress” error

Dear Ernesto, Error  "13007 SVAL Reset in already in progress" indicates that the servo ready signal is incorrect from one of your amps. There must be some other errors also indicating the servo am...

• View comment
• Created January 30, 2020 14:12
• 1 vote

1. Community
2. Troubleshooting — FANUC
3. Controlled start to normal operation

Dear Ernesto, Normally you always go with start cold when you turn on the main power. Since you started in the controlled start you are stuck in the controlled start. But no need to worry You can g...

• View comment
• Created January 29, 2020 14:01
• 1 vote

1. Community
2. Mechanical Design
3. Affordable Vision

  Bailey Chapman Can you Tell your range? The cost of Vision systems lies between 5k-6k$ Here I am stating some vendors if you're going to use the equipment for testing: Cognex, Keyence. They will ...

• View comment
• Created January 25, 2020 13:13
• 1 vote

1. Community
2. Troubleshooting — FANUC
3. White Screen Teach Pendant

Hi Braylen, You may have a damaged cable, you should Check the teach pendant cable CRS20 at the panel board. Also check the JRS15 Cable from Panel Board to Main board. Tell me if you I can help you...

• View comment
• Created January 23, 2020 13:29
• 2 votes

1. Community
2. Electrical Design
3. Fanuc Motor replacement

Dear Bailey, While replacing motor you will have to do remastering. If a robot has DCS you will have apply the re mastercount to the DCS. So are going to need the DCS code (standard 1111). Best!

• View comment
• Created January 19, 2020 12:34
• 1 vote

1. Community
2. Troubleshooting — FANUC
3. P300iA Zero position problem

Dear Ernesto! You've observed it right, the possible causes can be: Low voltage of the memory back up battery, Unusual external start signal. Incorrect parameter You can go with below remedies re...

• View comment
• Created January 18, 2020 16:40
• 1 vote