Muhammad Ishaq

1. Community
2. Electrical Design
3. Do anyone has an idea of the FANUC support or encoder replacment?

Hi Laurance!As per my knowledge, most of the FANUC robots are having small motors which are driving the wrists of robots. Moreover, the pulse coders of the motors are non-serviceable and are integr...

• View comment
• Created December 09, 2019 09:57
• 2 votes

1. Community
2. Troubleshooting — FANUC
3. Beep Sound

Hi Chadwick, Such parameter is inside the control box and is looking like a red wire which is connected to a round substance and is in shape of an audio speaker.  There is an another way to do this...

• View comment
• Created January 22, 2020 11:30
• 1 vote

1. Community
2. Troubleshooting — FANUC
3. The variations of actual and roboguide

Hi Miss Ellis, I am not sure whether I would be helpful in this case but I could recall a memory. One of my friends was working on a robot which was doing de-burring and he was having some serious ...

• View comment
• Created January 21, 2020 12:28
• 1 vote

1. Community
2. Troubleshooting — FANUC
3. How to send data from PLC to Robot

Hi, I will be happy to answer you. Can you please tell me whether or not your PLC has ability to communicate with ETHERNET IP such as AB does. There must be some communication in PLC with that allo...

• View comment
• Created December 19, 2019 05:41
• 1 vote

1. Community
2. Troubleshooting — FANUC
3. How to format FANUC TP file?

No I am not.

• View comment
• Created December 11, 2019 11:22
• 1 vote

1. Community
2. Troubleshooting — FANUC
3. FANUC hangs up...

Hello I would recommend you to contact FANUC. However, as per my knowledge, there are patches for both TP and controller of FANUC which are depending on the current software version which you are u...

• View comment
• Created December 11, 2019 08:14
• 1 vote

1. Community
2. Electrical Design
3. FANUC VLANs and Ethernet I/P Communication

Hi...I am going to ask you few questions that how are you having the ENET cards connected to the racks of the robot? Moreover, you have mentioned that you are having 3 cards...right? So if the dell...

• View comment
• Created December 11, 2019 07:47
• 1 vote

1. Community
2. Mechanical Design
3. ARC Mate 100i Problem?

Hi frankie! I have a suggestion for you.In my opinion your work cell must be having a safety fence or even a light screen for connection with emergency contacts.Thank You

• View comment
• Created December 10, 2019 16:51
• 1 vote

1. Community
2. Electrical Design
3. Test Motor for a short

Hello!Please proceed as follows for checking short circuit of a motor. First of all disconnect electricity from the motor.  Check the electrical connection and casing of the motor. Each sort of mo...

• View comment
• Created December 09, 2019 11:05
• 1 vote

1. Community
2. Troubleshooting — FANUC
3. The probing issue of the FANUC 16M

Oh I have miss-typed it before. It is 8898. I think you are not have it in older version to install it but I believe you will not be shown any of the 8000 series. However, the 9832 probe is on it t...

• View comment
• Created December 06, 2019 08:59
• 1 vote