Muhammad Ishaq

1. Community
2. Electrical Design
3. PART NUMBER EXPLANATION

Dear Braylen, Dimitry Vasilkov is very right here. All parts of the FANUC series are starting with A06B20A. Best of Luck

• View comment
• Created January 31, 2020 12:32
• 0 votes

1. Community
2. Electrical Design
3. Relationship among Angle of joint and Angular Momentum

Dear Turner, Gear Ratio is the factor on which the relationship among angular momentum and joint angle is dependent. Good luck

• View comment
• Created January 31, 2020 12:16
• 0 votes

1. Community
2. Troubleshooting — FANUC
3. Moving the variable of UL layer in to the register

Hi Juan,  Please mention the version of  software you are running. Thank you

• View comment
• Created January 30, 2020 09:44
• 0 votes

1. Community
2. Troubleshooting — FANUC
3. Waiting for startup

Dear Iqra, Most probably the software is not loaded. Try starting Boot Monitoring through pressing F1 and F5 while starting and after that you have to select the INIT Start for checking. Can you pl...

• View comment
• Created January 29, 2020 09:24
• 0 votes

1. Community
2. Troubleshooting — FANUC
3. Add Feature to roboguide

Hi Tooby Cooke, As per my knowledge, there is no such option. Thank You

• View comment
• Created January 29, 2020 09:14
• 0 votes

1. Community
2. Electrical Design
3. Mastering Data

Hello Tooby Cooke, As per the FANUC, you would be able to safely change the RAM Backup Battery. When you will run it for about 20 minutes, then turn the controller OFF, it is going to be alright. I...

• View comment
• Created January 29, 2020 09:01
• 0 votes

1. Community
2. Troubleshooting — FANUC
3. 4th axis of my robot is not returning to its joint

Hi Mr. Turner, Are you planning to move the robot through a program or through hitting "move to" with teach pendant. In both of mentioned cases it is to be moved in a linear motion but not the join...

• View comment
• Created January 28, 2020 09:10
• 0 votes

1. Community
2. Troubleshooting — FANUC
3. Abnormal indexer sweep: what to do?

Dear Laurance, I had this problem but it was under control, however, I then installed a safety relay for overheating. This solved the problem of my system to shut down after over heating. Right now...

• View comment
• Created January 28, 2020 07:10
• 0 votes

1. Community
2. Troubleshooting — FANUC
3. Stopping FANUC motion in mid of a cycle

Dear Frankie, There are numerous solutions for the problem that you are facing. It depends on the way you are calling programs or whether you having a PNS or Main? However, instead of using and int...

• View comment
• Created January 28, 2020 05:28
• 0 votes

1. Community
2. Electrical Design
3. THE FANUC WE Series issue

Hello Frankie, To me it seems like there is some problem with the casing of robot which is oxidized and losing its surface's grip with paint.

• View comment
• Created January 27, 2020 10:39
• 0 votes