Sarwat Anjum
Comments
-
Dear Toby cooke The alarm you are facing is possibly because DRAM (Dynamic random access memory ) Failure is detected, most probably due to power loss, as you mentioned the same. Remedy: Check the ...
-
Hi Ernesto, Try to probe the fault by checking ground cable of the controller. Confirm that the ground connection of the robot and controller are okay. If it is okay then you would have to change t...
-
Hello Ezequielo, You should try restarting the Roboguide and re-create the camera and disconnect the camera from robot and try another port it would clear if it is a port issue.
-
Dear Ernesto, It seems like your Teach Pendant Cable has a short. You should check it. Thanks
-
Dear Chadwick, Here I am stating few common points that you could consider while troubleshooting; Check for backlash by releasing the brakes of all axis one by one. This means you should be able t...
-
Dear Bailey, Changing a servo should not affect your DCS but you have to have a complete backup of the robot, So you can calibrate or modify your DCS if required.
-
Dear Braylen, You would have a name plate like shown below on your TP there yo ucan see the Type. Anyways A05 B-2518-C202#EMH is the one works on a R30iA controller
-
Hello Iqra, Power On Time: This item indicates the time during which the power to the controller is on. Servo On Time: This item indicates the time during which the system is ready for operati...
-
It can be because of the material that can cause higher resistance in the circuit which will result in poor weld quality because of low currents.
-
Dear friend! Spot-064 indicates that your welding point is not okay. Tell me if it is coming on every spot point?