Masako Cynesige
Comments
-
Dear Ernesto, Can you tell me your start type? PNS, RSR, or any other? May be your PLC is trying to start some specific program, which is different than the one you wanted?
-
Dear Losev, Your robot is waiting for Arc Established or Arc Detect signal, if it is not been set otherwise. After Arc starts, go check for the signal if it is stable. Plus you should also go to: M...
-
If the relay is also fine, then it seems like an electrical issue with your pendant's Main board, you can verify by connecting a good pendant if available.
-
Hi, You have already checked most of the things, I would suggest you to check one more thing here, Relay connected to the deadman swtich, the Panel Board RELAY located behind the controller door. C...
-
Dear Ezequielo I am attaching some visuals but You should make sure that there is a jumper wire between int 0 V and ext 0 also between int 24 V and ext 24 V, present on TB0P6.While on TBOP4 you sh...
-
Hello, I would like to add that false collision detection could be a sign of pending PM, you should check it first before replacing the motor.
-
Hi Ernesto, You can find robot's output on the EE connector (Picture attached below)
-
Hi bailey, There can be multiple causes for vibrations and abnormal sound. Check for below Causes and their remedies Respectively numbered. Cause: The robot is not firmly fastened to the base. Exc...
-
Dear chadwick, I know the formula but thanks for letting me know that fanuc doesn't provide this information. Have a good day!
-
I hope you find your answer but a newer teach pendant will not work on older robot and vise versa because the estops are dual channel on newer robots.