Muhammad Ishaq

1. Community
2. Electrical Design
3. The output wiring of the SFDO

Hi Laurance, I would say that pulse check has no concerns with the external relay that you are using. It is only serving purpose of safety of FANUC's output for its certification of CAT4. Actually,...

• View comment
• Created January 23, 2020 12:12
• 0 votes

1. Community
2. Electrical Design
3. The output wiring of the SFDO

Dear Laurance, I don't know whether it is CAT4 or not. I am not quite sure about it. Therefore, I would recommend you to talk to the company about it whether or not you have a shirt check among S14...

• View comment
• Created January 23, 2020 10:02
• 0 votes

1. Community
2. Electrical Design
3. The output wiring of the SFDO

Dear Laurance, it's always pleasure to answer your questions. For the solution of problem that you mentioned, you may try the DUAL CHANNEL, 2 No Contacts from the +24V DC and use the S14 and S34 fo...

• View comment
• Created January 23, 2020 07:05
• 0 votes

1. Community
2. Mechanical Design
3. Calculating the values of motor torque

Hi Howard, May be Losev has mentioned it correctly with each step. Try it. But I am going to let guide you through its mathematical calculations.

• View comment
• Created January 23, 2020 06:49
• 0 votes

1. Community
2. Troubleshooting — FANUC
3. Checksum of the Teach Pendent

Dear Laurance, This is generally illustrating that the software is corrupted and you need to reinstall it. Therefore, I would suggest to plug in the pendent to another robot and and rule it out. Go...

• View comment
• Created January 22, 2020 11:05
• 0 votes

1. Community
2. Troubleshooting — FANUC
3. Speed override problem of my FANUC

Hi Muhammad, You have to put $genov_enb in the variables on TRUE mode. You only have this problem when the TP is disabled right?

• View comment
• Edited January 22, 2020 06:55
• 0 votes

1. Community
2. Electrical Design
3. Is there any way for creating the Jog Frame without saving steps?

Dear Chang, You should have mentioned the type of controller which you are using.  Generally speaking when a new Jog Frame is taught then it is achieved by the time when last point of the method to...

• View comment
• Created January 22, 2020 05:50
• 0 votes

1. Community
2. Troubleshooting — FANUC
3. Setting up hold for CC?

Hi Chang, Can you please let me know of the type of controller that you are having in your FANUC robot? There is a very easy method of running the ghost with conv moments of the robot taking off wh...

• View comment
• Created January 21, 2020 11:48
• 0 votes

1. Community
2. Troubleshooting — FANUC
3. J2 Mastering out

Hi Laurance, I think there is nothing of electrical nature which may have caused the mastering to have a change. Even in cases of lower voltages or the bad amps of servo would not make such a case....

• View comment
• Created January 21, 2020 07:38
• 0 votes

1. Community
2. Mechanical Design
3. Simplifications needed!!

Hi, You can use external PLC for the purpose, and the robot can be order like a tool. For 1 do the routine 1. Thank You

• View comment
• Created January 20, 2020 10:21
• 0 votes