Muhammad Ishaq
Electronic Engineer by Heart and Mind
Comments
-
Hi Laurance, Juan is right, EE connector is the most straightforward way. The connections of the EE connectors will be of RI/RO and limited to 8 each on the mentioned robot. The outputs are sourcin...
-
Hi Chang, Let me give you a humble advise to search this forum and it has abundant information related to your question. Further, search for the posts related to LS instead of TP and you will be ab...
-
Hi Frankie, I would suggest you to investigate the $MOR_Structure variable for speed of TCP. DMR_GRP[i].SPC_COUNT - current encoder counts $PARAM_GROUP[i].$encscales[9] - pulses per degree or mmbes...
-
Glad to know that you backup. I think you are not having an options as you are losing performing tasks when doing it with init start. It usually happens when using older RJ controllers. If there is...
-
Dear Frankie, I am glad that your problem is resolved. Normally it happens that the architecture of the robot's is behind the architecture of computer. Therefore, grounded on the statement it can b...
-
Hi Chang,I think that if there is chance of the pressure measurement on the base of the robot input then I think you must relocate the sensor to airline output of the robot and then connect it acro...
-
Dear Chang, I have seen this question before and I believe that question had information regarding background picture, timer, and screensaver as well.
-
Hi Laurance, Are you having setup for compact flash drive to that of an PCMCIA adopter card? As far as I know the older RJ2 FANUCs are using these card which were in similar shape to that of PCMCI...
-
Dear Frankie, I will suggest you checking the circuit connections of safety equipment. For example if the safety circuit is failing to perform then it would go ON and OFF. Therefore, I am suggestin...
-
Dear Laurance, I have used the micrologix 1100 PLC before and it was with great success. It was having an Ethernet/IP protocol which was built for the programming of the software. I think the PLC w...